Units & precision

Choose the unit measurements read in, how lengths are written, and their rounding.

Control how Vellum shows measured values: the unit they read in, whether lengths are written in decimals or feet and inches, and how far they are rounded.

Units

  • Match drawing scale (the default): each sheet reads in its own scale's unit. Feet on an imperial scale such as 1" = 10', meters on a metric one such as 1:100, and inches on a sheet at full size.
  • Feet, Inches or Meters: every measurement reads in that unit.

Set it in Settings › General › Measurement units, or with Units in the Measurement section of a selected dimension or area in the Properties panel. It is one setting for every measurement in all your documents, not a property of one markup. Calibrating or picking a drawing scale sets it back to Match drawing scale. The bottom bar shows the unit next to the scale.

Length format

  • Match drawing scale (the default): feet and inches on an architectural scale such as 1/4" = 1'-0", written 15'-1 5/8", and decimals on any other scale.
  • Architectural: always feet and inches.
  • Decimal: always decimals in the current unit, such as 30.00 ft.

Set the default in Settings › General › Linear display format. To change one dimension, select it and pick Format (Decimal or 0'-0") in its Measurement section. A format set on a dimension always wins.

Precision

  • Decimal lengths and areas: Decimals in the Measurement section sets 0, 1 or 2 places.
  • Feet and inches round to the nearest 1/16".
  • Angles have their own format; see Angle tool.

These affect how the Dimension and Area tools report values, everywhere they show: on the sheet, in lists and in exports.